Winlink Setup with the Yaesu FT-710 Transceiver
I can't seem to get Winlink to want to work with the 710. So far I've only tried Vara HF with it.
About
half the time I get an issue where I can see Vara hears the audio for a
second or so then kicks off. To remedy this I have to go to the Sound
Control Panel and click on the speaker section, then just click OK and
get back out of the screen and then Vara magically starts to hear the
audio.
I have never gotten it to transmit anything though. I've
tried different combinations of radio that I've read on here and
elsewhere. Right now in Winlink it's set up as a 991A. I don't have
Winlink in front of me right now to remind what other radios I've
chosen. The 891 was one of them. I can't remember what else is listed
that I've tried. So far, I've only made things worse. Once I try to
transmit Winlink slows to a crawl, no longer does is do the click click,
click click, click click of trying to connect, but it goes click
(several seconds pass) click, then doesn't try again for about a
minute. Along with that issue it has never let me adjust the ALC, it's
always at zero, and when it does try to transmit the most power I've
seen it use is zero watts.
https://groups.io/g/ft-710
No comments:
Post a Comment
YAESU FT-710 discussions:
https://groups.io/g/ft-710
YAESU FT-710 website (CaSe Sensitive) shortcut.
bit.ly/FT710
bit.ly/ft-710
YAESU FT-710 discussions:
https://groups.io/g/ft-710
Yaesu website
www.bit.ly/yaesu2
www.bit.ly/yaesu4
https://www.yaesu.com/
https://groups.io/g/ft-710
.